laser keft

Laser Cutting Kerf

When the laser cuts through material it burns away a small amount of that material - this is called the laser cutting kerf. The amount of kerf is dependent on the material type and thickness, along with a couple other variables (including the lens on that particular laser cutter, air pressure, etc). Typically the kerf ranges from about .15mm to .2mm.

 
LI
 

To account for the laser cutting kerf, we offset the cut paths by the amount of the cutting kerf. Most of the time, we do this in our laser cutting software, but this can also be done in other CAD based programs (Illustrator, Sketchup, etc.)

It isn’t always necessary to offset cut paths to account for the kerf if something doesn’t need to be an exact fit. For example, if we’re cutting out a wooden 5” x 7” menu card, accounting for the offset isn’t necessary, as the piece will be just barely smaller than 5”x7” - measuring .49940” x .699040”.

One example of a project where accounting for the kerf IS NECESSARY is when we’re doing inlay. If we’re cutting an acrylic piece that a wooden letter will fit into, we need to account for the kerf to ensure that everything is a tight fit. If the kerf isn’t accounted for, the two pieces will not fit together.

 
Laser Cut Wood and Acrylic Inlay